Installation

CHROME LED COVER INSTALLATION INSTRUCTIONS:

STEP ONE: Before you get started,make sure to test fit each piece to vehicle

before removing the protective fill of the 3m-tape.

STEP TWO: Grab the rubbing alcohol prep pad and clean the surface of the

Tail light or head light ,this will ensure the best adhesion of the new

chrome led cover to your vehicle

STEP THREE: Remove the 3M-Tape protective film and carefully align the cover then press

It firmly into place,make sure the cover has adhered completely to the vehicle.

STEP FOUR: Connect the POSITIVE(red cable)and the NEGATIVE(black cable)with clips

please affix the cables properly with the cable tie.

HEAD LIGTH: CONNECT TO PARK LIGTH OR TURN SIGNAL CABLE (+)

TAIL LIGTH : CONNECT TO PARKING LIGTH OR TURN SIGNAL CABLE (+)

NOTE: The ambient air temperature needs to be no less 60 degrees F (15 degrees C)

Or above for installation.

There are no products to list in this category.

Continue

Warning: file_put_contents(/hermes/bosnaweb23a/b2087/ipg.marqueeautocom/vqmod/logs/Sat.log) [function.file-put-contents]: failed to open stream: No such file or directory in /hermes/bosnacweb07/bosnacweb07at/b2087/ipg.marqueeautocom/vqmod/vqmod.php on line 415LOG FILE COULD NOT BE WRITTEN